PDA

View Full Version : r200v with Nismo 4.63 ring&pinion


clearview
06-03-2004, 11:40 PM
i have installed a set of Nismo 4.63 gears in my r200v rear. the right output shaft no longers goes into the case as far as it did. the right oil seal now leaks. has anyone done this install and had similar problems.

DuffMan
06-04-2004, 01:01 AM
When you change the ring and pinion you need to reshim

cdlong
06-04-2004, 06:36 AM
the shimming only adjusts gear mesh, it shouldn't affect the output shafts (i could be wrong though), maybe you have something in the way. i'd pull it apart again and check it.

RBS14
06-04-2004, 09:35 AM
^^^^^

yes, it only adjusts gear mesh, you prolly have something wrong. you should put in new output shaft seals in too, it's basic and worth while.