PDA

View Full Version : Distributor wiring question - obdII - Altima plug


whippet
08-12-2012, 02:34 AM
No spark, car will not start. OBDI chassis, obdII motor & dizzy. I wired these according to KA to SR diagram floating around. Now one black wire is melted and I'm thinking I may have wired this incorrectly.
I think the multi-colored plug came off an Altima - fits perfectly.

Anyone know which wires go where?

http://img.photobucket.com/albums/v108/ReichsfuhrerSS/2012-08-11_19-40-17_67.jpg

whippet
08-14-2012, 04:31 PM
I think I found the problem but haven't fixed it yet:

Pins 5 & 6 were reversed.
Orange wire is connecting to pin 5 on the dizzy (12V). I had this wired to a black wire (ground of some sort). Pin 6 (black wire) should go to a ground, but I had it wired to the power wire (black/white).


The black/white wire was melted pretty badly. Car was not getting any spark or fuel. Probably b/c crank angle sensor was not getting power.

Q: could this wiring fiasco have fried my ecu?


Anyone looking for a distributor pin diagram, here it is:

http://www.google.com/url?sa=t&rct=j&q=ka%20sr%20distributor%20jwt&source=web&cd=6&ved=0CF4QFjAF&url=http%3A%2F%2Fjimwolftechnology.com%2Fwolfpdf%2 FDISTRIBUTOR%2520SR%2520KA%2520CHANGE%2520CAR%2520 TO%2520EXT%2520COIL%2520AND%2520TRANSISTER.PDF&ei=29EqUJLHGuTTyAHd1IHwCA&usg=AFQjCNE2D7_uMU8aqXDHb61DyWR0oUw-gQ