Valve cover fitting falling out

[QuickSpoolSR]

http://i654.photobucket.com/albums/uu268/johnw14151/11812-41B00.jpg


The fitting circled in green just keeps falling out and causing my car not to idle properly. What is supposed to be holding it in? do i need a new valve cover or what do i do? sorry if this is a noob question i have been googling for about 45 minutes with no luck

[memphis180sx]

try some hi temp silicone

[QuickSpoolSR]

just put it around the tube and shove it in and let it dry? what held it in there from the factory?

[QuickSpoolSR]

any other input or just try for the silicone?

[Sileighty_85]

Super Glue
Epoxy

Come on guy...

[Matej]

How does that affect idle?
I have seen SR's running it open, with a breather on the crankcase vent.

[hOngsterr]

its pressed in by factory, so just use a strong adhesive to hold it.

[beems240sx]

threebond works wonders. i use it on everything. its like $10 a tube but worth it for sure.

[QuickSpoolSR]

Thx guys Im gonna get some three bond

[ka4life87]

Doesn't affect idle at all, just to release crankcase pressure from blow by, i have a breather filter on my ka

[Sileighty_85]

How does that affect idle?
I have seen SR's running it open, with a breather on the crankcase vent.

If your running the VC nipple to the turbo intake pipe it creates a Vac leak

Doesn't affect idle at all, just to release crankcase pressure from blow by, i have a breather filter on my ka

You have a KA, its not the same in away...