PDA

View Full Version : Low beams dont work, high beams do


xGUNKX
04-05-2012, 02:16 PM
I got a S14 with a s15 front end. s13 sr if that matters.

But all the lights work except for low beams (prob cause brother hooks up jumper cables wrong when im asleep).

Buttttttttttttttt there is no low beam fuse which i would think it is since both went out. Would it just be the relays in the stalk?

TougeSR20Kid
04-05-2012, 02:41 PM
Did you install the front? Did you use one wire to hook up both lights? I've seen this happen on ppls cars when they do a half assed job on installing a front end. The s13 sr is not the issue and if ur saying that there is no fuse for them it has to be a wiring issue, either not hooked up to the power source the right way (no fuse) and the wire itself shorted out, or perhaps the ground came undone. Use a volt meter and check to see if ur getting power to the lights. Also are u by chance running HIDs?

xGUNKX
04-05-2012, 02:46 PM
I didnt install the front, i believe there are secondary fuses that connect to it (little black box with connector on it).
Ill go take pictures. They arent HID. I was going to buy HIDs to fix it though if that would work

Pictures of setup:

http://s367.photobucket.com/albums/oo119/elgunkwin/headlights/

buentellomma
04-05-2012, 03:21 PM
Had this issue with my hatch it turned out to be my headlight switch

xGUNKX
04-05-2012, 03:23 PM
Had this issue with my hatch it turned out to be my headlight switch

I took off the stalk, i couldnt take it apart due to it being ridiculous. But the back side of contacts didnt look bad

xGUNKX
04-05-2012, 11:23 PM
Any help??

xGUNKX
04-07-2012, 01:49 PM
Ok, so one of my relays are fried.
It is a Song Chuan
804-1A-C1-R1 12VDC
30A/12VDC

where can i get a new one of these or direct replacement?

future
04-07-2012, 02:06 PM
The junk yard