Var
01-03-2004, 07:48 PM
I got my rear pillow ball mounts for christmas(thanks mom) and i tried to get them installed today. the guy installing them for me says they wont fit. The fronts worked fine but i guess ground control springs are a little smaller in diameter than Tein springs...soooo the rear springs dont sit well under the pillow ball mount. I told they guy to put all the stock shit back on till i figure out what to do. The stock spring & ground control spring in the rear are about 63.5mm...the only thing i can think of is to get the bottom of the pillow ball mounts machined down to 63.5mm. Anyone else done this before?