PDA

View Full Version : Recent Mishimoto Install, Cap Problem?


Nicelyphe
02-12-2011, 06:21 AM
Hey friends, well a week ago I had a sr20det swap in my 93 Nissan 240sx. This week i noticed smoke coming from the bay and its consistent every time the car gets to warming temp. Open the hood and come to notice that there is some coolant on the top cross member, little down on my front mount, and some sitting around the filler neck area of the radiator. Any reason why the cap may not be holding pressure? Maybe its not the cap and could be the filler neck? Any way i can diagnose the situation, since id rather not really go through the warranty process unless i really really have to due to needing my daily driver.




*This thread has nothing to do with degrading Mishimoto as a manufacture.

s14canyoncity
02-12-2011, 06:41 AM
Temp read out?

Is the car over heating at all or your trying to say your rad is leaking fluid from the filler neck. If its just leaking the rubber on the radiator cap could be worn out hence thats why its leaking or not holding pressure.

Nicelyphe
02-12-2011, 06:49 AM
I only got stock temp gauge at the moment. Cap and radiator has only been in use for a week. Temp gauge is always at C as im driving unless i let the car idle for about 10-15 mins, it will slowly start to move up, but never close to H then once i start to drive the temp gauge slowly goes back down to C

CrimsonRockett
02-12-2011, 08:41 AM
Mishimoto radiators are notorious for having cap issues.

Almost every single person I know that has run a Mishimoto radiator has had to change out the radiator cap.

Just pick up a new one at your local auto parts store and be done with it.

Nicelyphe
02-12-2011, 08:47 AM
Stock 240sx cap work just fine?

Propaganda
02-12-2011, 09:00 AM
Get a Coolant Pressure Tester from Autozone. When I rented it from there, they didn't have the adapter for the radiator, so I just bought it from them for like 10$.

It tests radiator cap and cooling system

tinys s14
02-12-2011, 09:14 AM
I had the same problem when I installed my mishimoto...I put my oem back on and it was fine

Nicelyphe
02-12-2011, 09:18 AM
Alright cool, Ill do this and let you guys know.

Ali 556
02-12-2011, 12:40 PM
Mishimoto radiators are notorious for having cap issues.

Almost every single person I know that has run a Mishimoto radiator has had to change out the radiator cap.

Just pick up a new one at your local auto parts store and be done with it.


+5865945725438986497538642653287087537515739775086 846257438

replace it with nismo cap (1.5 bar) or a z32tt cap (its 1.4 bar and can be found used)

nismo cap is 30$ on frsport.com

Silverstreek
02-12-2011, 02:40 PM
+5865945725438986497538642653287087537515739775086 846257438

replace it with nismo cap (1.5 bar) or a z32tt cap (its 1.4 bar and can be found used)

nismo cap is 30$ on frsport.com

didnt think the Nismo cap will fit? i tried on my Mishimoto and couldnt get it to work... but, i guess i'm lucky, cause no probs with my cap/filler area leaking yet.

97nismo
02-12-2011, 04:56 PM
its the cap...................... got the same radiator swap to stock cap

Nicelyphe
02-13-2011, 10:29 AM
Yea, thanks guys, got stock cap on. Sealed that up, after driving around I noticed another coolant leak that spring up now I believe. Was to dark to tell at the moment, but there was drips down on the drivers side corner of the rad, below the area of the drainplug =\. Maybe now that its holding pressure from the cap its blowing out of the plug? Whatta mess lol.