PDA

View Full Version : J4 Ecu with Non Type X blacktop Motor.


fullthrottle
04-09-2010, 09:04 AM
Im only getting spark in cylinder #1. Where can I find the information to repin my ecu or is the J4 backwards compatible.

rubhamusan
04-09-2010, 10:59 AM
Gotta repin five wired 3 are coil 2,3,4 and cas 180 and 1 degree.
Just find a 62 and j4 pinout. Only takes about 10 min todo.

rubhamusan
04-09-2010, 11:07 AM
http://i9.photobucket.com/albums/a90/kingtal0n/62toJ4.jpg

fullthrottle
04-09-2010, 12:28 PM
You are the man. This is going to be easy now I dont have to go swap for a different ecu

rubhamusan
04-09-2010, 07:00 PM
Yeah but one thing maybe 2. I have a tx black top with red top harness and ecu. It ran rich until I changed the temp sensor and O2. The txsr uses a oval temp sensor and plug.and the O2 is larger than the red top.hope this helps. If my car turned off it wouldn't restart unless I pressed the gas all the way down when cranking.

rubhamusan
04-09-2010, 07:02 PM
Oh and I'm not really the man I just googled it thank fresh alloy if anything.

fullthrottle
04-10-2010, 10:35 AM
Well thanks to you AND fresh alloy I drove my car last night. It pulls like a champ. It felt really good to finally get to drive it after all the work. I just repinned the ecu and ban fired up. Still idles a little funny. Sits at like 2k until warmed up then when it trys to drop to 800 it just dies unless i give it some gas. Vaccum leak?