View Full Version : 93 300zx misfiring
nate29
04-04-2010, 05:21 PM
Ok got a problem with my 300zx i put a new timing belt on and the hole 9 yards with it.Timing marks set perfect.but now that its all done its missfiring started up fine any ideas of what this could be.
daxnizmo
04-27-2010, 07:25 AM
Have you checked your connectors on the injectors? Or maybe the PTU? I had the same issue and found the connectors had a lot of corrosion. Cleaned the up with a pick set and electric motor cleaner, then put some dielectric grease on after.
240sxxs
07-29-2010, 03:06 AM
wat PTU ...
txq45
07-29-2010, 11:45 AM
Run codes .....?
Wiggle the wires on the PTU
Two-One-Six
10-11-2010, 09:56 PM
It may be bad injectors...O-rings tend to go bad after awhile..Relatively easy fix. Z32's are notorious for having injector problems. I agree with daxnismo on the injector ends. I would check those first, and if any or some or bad it's not hard to install new connectors.
vBulletin® v3.8.11, Copyright ©2000-2024, vBulletin Solutions Inc.