s13 sr into s14 driveshaft help

[blksylv]

well heres the scenario , im in the process of swapping a s13 sr into my s14 and doing a 5 spd swap also and upon trying to put the driveshaft into the tranny it wouldn't go all the way in. we tried lubing it and it still didn't work and im stumped. the driveshaft is from a non abs s14 and its going into a non abs s14 . but now its kinda stuck n the tranny. the yolk had a lil bit of rust on it from setting tho. if anyone has had this problem or any ideas please let me know. thanx

[brewster240]

you got an s14 manual shaft right?

also, pop the dust over off the back of the trans.

[blksylv]

ya its a manual shaft and the dust cover has been removed

[projectRDM]

Pull it out and inspect for damage to the yoke or splines. Also look for debris inside the shaft, sometimes a used shaft can get trash in it while sitting.

[blksylv]

kewl ill check it when we back it out thanx

[nismo_drifter]

so it will go in just not all the way in right...there is like about 1 inch that is not in? because mine is the exact same and i run it to this day with no problems...i just thought that was how it was, becasuse of the swap...

[blksylv]

well we got it and then tried 2 start it and now the injectors aren't firing getting fuel to the rail and a signal from the injectors . tried a couple different sets of injectors and still nothing. also tried 3 different ecus also and still nothing so now im stumped . the harness is a prewired one from wiring specialties. checked cas and no signal there also any ideas?