PDA

View Full Version : z32 brake clearance question

skylindrftr
03-07-2009, 10:36 PM
No this isn't about rim clearance. Moving on, I am putting 300zx iron 30mm cals up front and my buddy gave me some 30mm rotors from an alum setup. He told me they were machined 1mm down on both sides when resurfacing. I put them on the car to test fit and there is a god awful amount of space between the pads and the rotors (yes I know it will compress when the pedal is pressed). I was wondering if this was safe, I am going to the track in about a month or so, should I just buy new rotors?

Pics:

http://i5.photobucket.com/albums/y159/jdm240/DSCN2802.jpg
http://i5.photobucket.com/albums/y159/jdm240/DSCN2803.jpg
S14DB
03-07-2009, 10:51 PM
Do you have a Caliper(Ruler) to measure how thick the Rotor is?
skylindrftr
03-08-2009, 12:48 AM
It is slightly thicker than a q45 rotor, I know that much, I'll take a reading tomorrow and see what it is.
skylindrftr
03-08-2009, 06:19 PM
Okay the rotor thickness is about:

28.5 mm
S14DB
03-08-2009, 10:06 PM
28mm is the minimum. You'll be fine but I don't think you will be able to resurface them again.
skylindrftr
03-09-2009, 12:02 AM
Cool thanks s14 db =)