PDA

View Full Version : Hey guys i need some ideas

moses
10-12-2008, 03:55 PM
I just took a dremel to my freddy intake manifold for about 4 hours trying to get it smooth and i need to find out a way too clean the inside. i just rinsed it in my tub with hot water and i still dont feel safe enogh to put it back.
any suggestions?
Goldeneye9mm
10-12-2008, 04:26 PM
get ahold of someone w/ an air compressor and tape of the 3 holes closest to the throttlebody opening and blow inthe last one w/ like a circular pattern anything that doesn't come out the throttlebody hole will get stuck to the tape then wash it out again
johngriff
10-12-2008, 04:36 PM
Shot Peen.
projectRDM
10-12-2008, 04:40 PM
Hot tank. Carb cleaner. Urine.
moses
10-12-2008, 06:21 PM
sounds like a plan thanks guys.
moses
10-13-2008, 06:39 PM
ok i did the pressurize thing with tape and it got a bit more out. The problem is when I go in with my little magnet there are little specs of metal that still come out. I got as much as i could but do you think these little pieces could really hurt my engine?
projectRDM
10-13-2008, 07:12 PM
ok i did the pressurize thing with tape and it got a bit more out. The problem is when I go in with my little magnet there are little specs of metal that still come out. I got as much as i could but do you think these little pieces could really hurt my engine?

Aluminum isn't magnetic, what all shit are you picking up in there?
s13 @ fullboost
10-13-2008, 07:29 PM
Hot tank. Carb cleaner. Urine.

haha that is the best way to go for suree
bejota180sx
10-13-2008, 07:43 PM
are freddy manifold made of aluminum?

if u did the pressure thing i woud recomend while in the hot water get some soap or something like that take a brush or something like the toiler cleaner brush (LOL!) and scrub the inside a bit in case some shavings are sticking to the inside...
Ben G
10-13-2008, 07:52 PM
Urine.


defiantly the best way to clean anything
cotbu
10-14-2008, 02:54 AM
Urine (tasteless kind), Cold Carb and compressed air.
moses
10-14-2008, 10:18 AM
the maifold is aluminum but i guess it was the stuff i was grinding with. not sure? hopefully i got everything. not much else i could do. guess ill find out when i get done with this turbo upgrade witch is a lot harder for me than everyone says it is.
one more off topicquestion. if my ecu is getting tuned for a z32 mafs, do i still need to program my afc neo to 4in 2out or whatever it is to read a z32 maf or do i just let it be?
mrmephistopheles
10-15-2008, 08:35 PM
Urine (tasteless kind)

You know.... I'm just not going to ask...
Sileighty_85
10-15-2008, 08:43 PM
Garden Hose with sprayer nozzle, or power washer (a bit extreme)