PS pump -10 fitting, anyone sell these?

[khilgers]

I've been trying to get a hold of a company in IL that makes these, but I can't seem to contact them. So does anyone know of a company that makes these for the SR motors. Basically just a steel flange with a steel -10 fitting welded to it.

http://streetkaizo.com/tmfo/wp-content/uploads/2008/04/img_1873.JPG
http://streetkaizo.com/tmfo/wp-content/uploads/2008/04/img_1875.JPG

[boozels]

you can always have a welder make one

[khilgers]

it's either buy one, make my own steel one, or cut the end off my stock fitting and weld on a -10 fitting on the end.

[GSXRJJordan]

...cut the end off my stock fitting and weld on a -10 fitting on the end.

There's your best bet. I've never been able to find one already made.

[liliechen]

I used a M14 x 1.5 tap the port(no drilling needed for M14), then get a m14 x 1.5 to an-10 adapter with some teflon tape.

[Inland180]

There's your best bet. I've never been able to find one already made.
This is the best option up to now. easy to do. just take it to some one that can weld it. shouldnt cost you much.

[twistedsymphony]

contact these guys... it's what they specialize in:
http://www.purechoicemotorsports.com/index.cfm/page/ptype=results/category_id=71/home_id=71/mode=cat/cat71.htm