T28 Coolant lines:

[rps13sr20det]

Hey ya'll,
I've been searching on the board for the last couple days while im doing my turbo conversion to a T28. I removed the T25 this morning, managed to maintain all hard lines going from the turbo. On my T28 I have a steel braided oil feed line, but It looks like the car that the turbo came off did not run coolant to the turbo. In your opinion will running coolant on a Stock SR setup effect the turbo life on a T28....

Thanks for the input :)

[burnsauto]

run them if you can. The cooler a turbo can run, the better off it is.

[rps13sr20det]

my problem is: the coolant bolts that came off the T25 do not screw in fully to the T28. What is the correct size of bolt?

[rps13sr20det]

i've searched, what is the correct nissan banjo fitting for T28?

[John_R]

Both T25 coolant banjos fit my T28. You can also use the banjo bolts from an automatic transmission coolant lines. I discovered that they are identical to my stock turbo banjos.

That's about all the help I got.

[Sileighty_85]

if your banjo bolts are FUBAR they are the same as the Z32TT Turbo's

[rps13sr20det]

thanks so much guys! really appreciate the help. i just re thread the coolant sides of the turbo, They were really rusty and had nothing screwed in. :)