View Full Version : boost source fittings...? what are you guys using?

03-27-2008, 02:11 PM
I searched some on this subject but with the nature of the keywords it can got a little annoying. My question is as stated: What type of fittings are you guys using to connect those tiny boost gage lines to your existing vacuum /boost sources. I looked through some Parker catalogs for some small tube compression tee fittings but they're not as clean looking as I had envisioned. So lets poll the audience; anyone out there find something that works good here?:aw:

On a side note, Autometer, as I'm sure other manufactures do, supplies you with a rubber boot for the tiny line to connect to what looks like a 0.125" barbed tee. Is that the solution?