PDA

View Full Version : Hub Fitment

mattack69
03-24-2007, 12:48 PM
Hey just ran across these hubs in a container my buddy recieved and was wondering if anyone knew what kind of hubs they are, and if so will they work on the 95' s-chassis. I want to say the are 300z rear hubs but what year I have no clue. Needing some help please. Thank you in advance!!!
mattack69
03-24-2007, 07:49 PM
bump bump bump
projectRDM
03-24-2007, 07:52 PM
I'd answer you, but you seem to hate when I make a comment about anything.
A Spec Products
03-24-2007, 07:53 PM
I'd answer you, but you seem to hate when I make a comment about anything.

OOOOH

Burnnnn

Got you gooooooood

That doesn't look like 300zx ones though
mattack69
03-24-2007, 07:54 PM
LOL I dont hate ya man I just dont like playing games. I know you know your shit on the s chassis I never said you didn't, I just don't know where you took me the wrong way but believe me I don't hold grudges and or hate anyone.
projectRDM
03-24-2007, 07:57 PM
Z32 NA or R32/R33/R34.

To be certain, a forward pic would be ideal, but the TT or BNR hub will simply have a larger spline area for the bigger diameter axle.
mattack69
03-24-2007, 07:59 PM
Ok give me a few
mattack69
03-24-2007, 09:36 PM
Ok here we go, I sand blasted them, repacked the front bearings with some greasy time, and repainted em' all with some high temp Barb-Q Krylon for the time being. The rears got new 95 SE studs in em. I don't know if the fronts are from a S14 or not but after I compaired them to mine they look the damn same. Thank you again.
projectRDM
03-24-2007, 11:46 PM
NA.

You can also tell by the pin on the top, TT models have a dual drilled flange and the pin can be fitted on either side for the larger kingpin to align up to.
mattack69
03-25-2007, 12:54 AM
So your saying these will work on my wifes 95 with no extra bits and pieces? I just need to swap out the old hubs with these and then the XD9's will be on the damn car finally... Thanx for your help big time!!!
mattack69
03-25-2007, 05:59 AM
bumptizzle...
projectRDM
03-25-2007, 08:35 AM
Direct bolt on. If you want the flanged bearing for later use with Z32 ebrakes you can even swap the hubs with a press and place the 5lug hub into the existing 4lug bearing.
mattack69
03-25-2007, 02:15 PM
Sweeeet thanx again man. The wife is happy now!!!