PDA

View Full Version : Removing fenders??


94plum
09-10-2006, 06:27 PM
I bought a new fender and i was planning on taking off my stock one before the new fender came in but there is one screw located on the inside of the fender when the door is opened...my problem is i cannot reach the screw b/c the fender is dented...is there any other ways i can take the screw out??
I tried a screw driver, wrench and drill
What else can i try:duh:

LB.Motoring
09-10-2006, 06:28 PM
Pry that b*tch back hahaha

frank98dsm
09-11-2006, 12:28 AM
dont mess up that little bracket if you can cut the fender

idlafie
09-11-2006, 01:01 AM
Your answer's simple. Take the tire off & remove the screws holding the plastic fender liner in place. Once the screws are out, remove the plastic fender liner. Removing the plastic fender liner will give you access to the inside part of the fender. Use a pry bar to push the damaged fender portion out of the way & then use a Bolt-Out screw extractor kit to remove your stuck screw.
Hope this helps...
ID