dohc wiring

[Aldus]

Im doing the dohc swap and everything is working fine in the guide except for one piece of wiring inside of the engine bay.

Under the fuse box near the battery there is a connector on the dohc body that has 2 prongs and has a yellow / blue and a yellow / red wire coming out of it. On the sohc it is a connector that has 4 wires on it red /blue, orange, yellow / blue, and black. Im assuming I need to splice these wires together to get everything working, but Im not sure which to splice the dohc body connector onto. Im guessing either the yellow / blue to the yellow / blue and the yellow / red to the red / blue or the yellow / blue to the yellow / blue and the yellow / red to the black.

Ive searched all over for info on this but I havent been able to fine anything.

Any help appreciated.

Chris

[Aldus]

http://i50.photobucket.com/albums/f310/aldus2/DVC00001.jpg
Connector coming out of the dohc engine harness (plugged into the cut dohc body harness plug)

http://i50.photobucket.com/albums/f310/aldus2/DVC00002.jpg
4 wires from the sohc body harness with the plug cut off

http://i50.photobucket.com/albums/f310/aldus2/DVC00003.jpg
another picture of the 4 wires

http://i50.photobucket.com/albums/f310/aldus2/DVC00004.jpg
picture of the plug on the sohc engine

http://i50.photobucket.com/albums/f310/aldus2/DVC00005.jpg
another pic of the sohc engine harness plug

http://i50.photobucket.com/albums/f310/aldus2/DVC00006.jpg
overall pic of the area

http://i50.photobucket.com/albums/f310/aldus2/DVC00007.jpg
the dohc plug

The engine is turning over and cranking but there is no spark at all. Im going to get the coil checked right now, but it was working fine while in the other car.

[Aldus]

Coil is fine, just got back from getting it tested.