|
|
|||||||
| Chat General Discussion About The Nissan 240SX and Nissan Z Cars |
|
|
Thread Tools | Display Modes |
10-12-2012, 01:38 AM
|
#1 |
|
Zilvia Addict
 
Join Date: Dec 2010
Location: San Diego, CA
Posts: 957
Trader Rating: (39)
 Feedback Score: 39 reviews
|
PBM subframe riser install
Problem solved see below!
 just recently installed my PBM subframe risers, read up on the thread they provided.. http://www.gtfactory.jp/cms/e107_fil...9_p1040244.jpg In the thread it was recommended to hammer/cut the uni body where the camber arms are located, but i noticed my arms are closer than the car pictured, so i have an even shorter travel. Also if i were to hammer both sides of my uni body I'd have problems in pic2 because i have EGR lines right there  . I have bombarded Dan and Martin with questions and they've gladly answered them all And they will be getting a call tomorrow lol but im just trying to gather input on this situation. If the pictures suck ill try and snap some better pics soon.pic1  pic2(pass side) EGR lines  pic3(driver) uni body non cut/hammered  note: pictures taken with the car on the ground, car is s14
__________________
 IG - allen.kerose Last edited by Tempo; 10-24-2012 at 02:07 AM.. |
|
|
| Sponsored Links |
| Bookmarks |
| Tags |
| install, pbm, psm, risers, subframe |
|
|
Threaded Mode