NY NEW Planted LOW mount seat bracket, 300zx Caliper, 20mm spacer, S13 Lower harness...

[gills]

Planted LOW mount seat bracket. NEW, INSTALLED FOR 5 MINUTES THEN TAKEN OUT SOLD
20mm 5x114.3 P.C.D Aluminum spacers (one missing a lug stud)SOLD

S13 KA24DE Automatic tranny Lower engine/transmission harness $50 SHIPPED:



I have 2 passenger side cast iron 300zx brake calipers. One OEM (Sumitomo) the other I don't know. Both with clips, pins, etc$50 SHIPPED FOR OEM, $30 SHIPPED OTHER ONE:

[Dripht240]

30 bucks shipped to ct for the spacers?

[nissan2787]

31$ shipped to ct for the wheels spacers lol

[gills]

ha!

PM's sent

[Dripht240]

ha nice irwin. thanks for trying to one up me.

[miamiman323]

How low does that mount make the seat? Looks like it would be very low which is key, when you installed how did it look?

Will it fit in an s14?

[gills]

Originally Posted by miamiman323

How low does that mount make the seat? Looks like it would be very low which is key, when you installed how did it look?

Will it fit in an s14?

The problem is the seat I'm using is an XL version (Momo Daytona XL) so it was too wide to fall in between the brackets, which consequently is way too high for me and other drivers on my team. I'm going to have to do some custom fab work. If your seat is narrow enough it will definitely drop it pretty low. Check for pics on the web, you'll see how it supposed to ideally fit.

[miamiman323]

Reason i asked was i have a wide seat that wouldnt fit between the BC rails. This looked like a cool alternative but i guess not. Thanks anyway.

[NEdriftah]

Originally Posted by miamiman323

Reason i asked was i have a wide seat that wouldnt fit between the BC rails. This looked like a cool alternative but i guess not. Thanks anyway.

These seat rails are AWESOME!!!!!! I have a Cobra Suzuka GT seat that would not fit BC rails, or the Circuit Sport double lock rails. The seat fits between these rails easily, and the seat is SUPER low. I wish I would have found this deal, I bought them for $140 shipped.

To give you an idea, the mounting holes on the outside of my seat were 17", that's pretty wide.

BUMP FOR AWESOME SEAT RAILS!!!!!!!!!!!!!!!!!!!!!!!!!!!

[NEdriftah]

Originally Posted by gills

The problem is the seat I'm using is an XL version (Momo Daytona XL) so it was too wide to fall in between the brackets, which consequently is way too high for me and other drivers on my team. I'm going to have to do some custom fab work. If your seat is narrow enough it will definitely drop it pretty low. Check for pics on the web, you'll see how it supposed to ideally fit.

Seat would not fall between rails on front or back? Or at all? I got my seat to work with these and my seat is 17" wide at mounting points.

[gills]

Originally Posted by NEdriftah

Seat would not fall between rails on front or back? Or at all? I got my seat to work with these and my seat is 17" wide at mounting points.

More toward the front. The rails would've needed to be ground pretty significantly and at that point I would start questioning the structural integrity of them, which is why I've decided to go custom. My helmet also needs to be a certain distance below the main hoop of my roll cage as per the rules. Plus, the tallest guy on my team is 6'4" so there is no two ways around it. Need to go custom.