|
|
|||||||
| Engine Tech Technical discussion related to all relevant engines such as KA, SR, RB, CA, 2JZ , L24/26/28, VG, VQ, and LSx series. |
 |
|
|
Thread Tools | Display Modes |
07-29-2018, 08:40 PM
|
#1 |
|
Zilvia Member
 Join Date: Feb 2008
Location: Milwaukee
Age: 39
Posts: 249
Trader Rating: (1)
 Feedback Score: 1 reviews
|
Too much fuel when primed/SR20
I'm trying to get my recently swapped SR20 to start. It has the stock FPR and stock fuel pump. I pulled the fuel line and put it into a bottle to make sure it was getting fuel. I turned the key and on and it poured a decent amount of gas in which filled up less than half of the bottle of water. I noticed that gas continued to drip out of the fuel line though until the bottle was overflowing. Is this normal, or is it happening just because I had the fuel line pointed down and it was just gravity? Either way I am trying to get my swap to start. It has been sitting for a few years. New gas, all new wiring harness.
|
|
|
| Sponsored Links |
|
07-30-2018, 05:30 AM
|
#2 |
|
Nissanaholic!
 
|
it primes for set amount of time, 2 seconds IIRC.
the system primes to build pressure, since you have an open loop it cant build pressure. sounds perfectly normal to me.
__________________
@UpshiftEngineering |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
