SR20DET flex section location opinions needed
Hi all,
Red top SR20 in my S14. Poly engine mounts, T28, 3" elbow and 3" downpipe with no flex section.
Ive got an extra 6" long, 3" diamter flex section laying around and I figured I SHOULD utilize it.
It seems that If I weld in the flex halfway down the downpipe (where most manufacturers place them), it will rub on the body,
I also could weld it in where the test pipe is (which would clear the body), but that seems quite far back.
Any opinions here?
Thanks,
|