240SX ISIS Stainless Steel Braided Power Steering Line Install and Review - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

(Yoshi) · 08-30-2009, 09:49 AM

240SX ISIS Stainless Steel Braided Power Steering Line Install and Review

A plague to the 240 family is a soft, leaky power steering system. In an effort to help correct this, Enjuku Racing’s ISIS product line offers a Stainless Steel Power Steering Line. On top of replacing leaky lines and improving steering feel, the line also allows for more clearance when going turbo and makes converting from 1989/1990 power steering systems to 1991+ much easier.

The line comes with everything you need for installation. The installation it’s self is not bad at all. Just expect to get a little messy with the power steering fluid.

After installation I noticed the steering feel is more direct and turn in is more responsive. I have not experienced any leaks from the line after about a month or so and a drift event.

Tools needed:

A set of metric open ended wrenches
Drain pan
New Power Steering fluid

Installation:

Step one: Make some room for you to work by removing the air filter and mass air flow sensor.

Step two: Place a drain pan under the rack to catch the fluid and remove the bottom line going into the steering rack.

*note* mine was old and broke so don’t be surprised if yours does too

Step 3: Remove the bracket holding the lines inside fender.

Step four: Remove the top part of the hose from the power steering pump.

Step five: Insert the fittings into the PS pump and Rack separately from the line using the washers that came with the line.

*note* Be careful of the o-ring on the fitting and don’t lose it.

Step six: Install the line onto the fittings and snug it down.

Step 7: Fill with new fluid and give the wheels a few turns back and forth with the engine running to circulate the fluid and you are good to go!

08-30-2009, 09:49 AM	#1
(Yoshi) Leaky Injector Join Date: Mar 2008 Location: Cookeville, TN Age: 35 Posts: 74 Trader Rating: (0) Feedback Score: 0 reviews	240SX ISIS Stainless Steel Braided Power Steering Line Install and Review 240SX ISIS Stainless Steel Braided Power Steering Line Install and Review A plague to the 240 family is a soft, leaky power steering system. In an effort to help correct this, Enjuku Racing’s ISIS product line offers a Stainless Steel Power Steering Line. On top of replacing leaky lines and improving steering feel, the line also allows for more clearance when going turbo and makes converting from 1989/1990 power steering systems to 1991+ much easier. The line comes with everything you need for installation. The installation it’s self is not bad at all. Just expect to get a little messy with the power steering fluid. After installation I noticed the steering feel is more direct and turn in is more responsive. I have not experienced any leaks from the line after about a month or so and a drift event. Tools needed: A set of metric open ended wrenches Drain pan New Power Steering fluid Installation: Step one: Make some room for you to work by removing the air filter and mass air flow sensor. Step two: Place a drain pan under the rack to catch the fluid and remove the bottom line going into the steering rack. note mine was old and broke so don’t be surprised if yours does too Step 3: Remove the bracket holding the lines inside fender. Step four: Remove the top part of the hose from the power steering pump. Step five: Insert the fittings into the PS pump and Rack separately from the line using the washers that came with the line. note Be careful of the o-ring on the fitting and don’t lose it. Step six: Install the line onto the fittings and snug it down. Step 7: Fill with new fluid and give the wheels a few turns back and forth with the engine running to circulate the fluid and you are good to go!