|
Tech Talk Technical Discussion About The Nissan 240SX and Nissan Z Cars |
|
Thread Tools | Display Modes |
10-05-2015, 12:53 AM | #1 |
Leaky Injector
|
Need help aem vss issue
Hey everyone before I start Heres my setup info that relates to the issue
S14 1995 Rb25det engine Wiring speaclities pro harness Z32 tranny with rb bell housing Z32 speed sensor 2 wire with ka knock sensor connector to connect to rb harness V2 aem Need help with my vss, I went in to aem to setup my 2 step and it wouldn't release out of 2 step rpm rang due to finding out my aem s2 is not getting a vss signal it sits at zero. so I set my 2 step to always off at the moment. SO I need HELP to setup vss tables to work and calibration for 300zx speedo in s14 with RB. Yes my cluster gets signal but it reads double the mph and my aem dose not get signal as show on laptop it sit at zero while driving. So any input would help or a screen shot of your Cailbration would be great. Here my vss setup on the aem Vss allowed diff 200 Vss cal*8 on Vss calibration 56 Vss diff rest count 3 Vss filter on Vss input T3 Vss smooth on T3 falling edge on T3 rising edge off T3 h sens below 0 rpms T3 L sens. Above 0 rpms I have done research, I have not been able to find any information that has proven fix and relate's to my setup. I've seen a few threads on supra forum with simlar problems but they all end up never finishing the post and rebumped years later with a new person with same issue that needs solved. Last edited by turboS14kid; 10-08-2015 at 09:44 AM.. |
Sponsored Links |
Bookmarks |
Tags |
aem, rb25, s14, vss, z32 |
|
|