CA ☆ ☆ ☆ S13 Cusco Tension Rod + GKTech Offset Bushings ☆ ☆ ☆ - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

xs420240sx · 06-30-2013, 11:10 PM

I have a set of S13 Cusco tension rods. They did not come with any spacers, but I managed to take some measurements and picked up some GKTech offset bushings for extra wheel clearance. They are used, but still in good condition. The boots have kept the rod ends nice and still over the years. I'm asking $175 shipped in the US.

These will work on an S14 if you would like to use them, but will not allow for the same measurements as a proper S14 tension rod would.

xs420240sx · 07-01-2013, 03:45 PM

☆☆☆☆☆☆☆☆☆☆

xs420240sx · 07-02-2013, 04:05 AM

☆.☆.☆.☆.☆.☆.☆.☆.☆

Hiighboost2 · 07-02-2013, 06:28 AM

Part the offset bushings?

xs420240sx · 07-02-2013, 02:17 PM

no. theyll only fit a few specific rod ends and then id be left with tension rods with no spacers again.

06-30-2013, 11:10 PM	#1
xs420240sx Zilvia Junkie Join Date: Jun 2011 Location: CA Posts: 595 Trader Rating: (5) Feedback Score: 5 reviews	☆ ☆ ☆ S13 Cusco Tension Rod + GKTech Offset Bushings ☆ ☆ ☆ I have a set of S13 Cusco tension rods. They did not come with any spacers, but I managed to take some measurements and picked up some GKTech offset bushings for extra wheel clearance. They are used, but still in good condition. The boots have kept the rod ends nice and still over the years. I'm asking $175 shipped in the US. These will work on an S14 if you would like to use them, but will not allow for the same measurements as a proper S14 tension rod would.

07-02-2013, 06:28 AM	#4
Hiighboost2 Zilvia Junkie Join Date: Jun 2008 Location: Houston, Tx Age: 37 Posts: 368 Trader Rating: (32) Feedback Score: 32 reviews	Part the offset bushings? __________________ Instagram @hiighboost @iasperformance

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

07-01-2013, 03:45 PM	#2
xs420240sx Zilvia Junkie Join Date: Jun 2011 Location: CA Posts: 595 Trader Rating: (5) Feedback Score: 5 reviews	☆☆☆☆☆☆☆☆☆☆

07-02-2013, 04:05 AM	#3
xs420240sx Zilvia Junkie Join Date: Jun 2011 Location: CA Posts: 595 Trader Rating: (5) Feedback Score: 5 reviews	☆.☆.☆.☆.☆.☆.☆.☆.☆

07-02-2013, 02:17 PM	#5
xs420240sx Zilvia Junkie Join Date: Jun 2011 Location: CA Posts: 595 Trader Rating: (5) Feedback Score: 5 reviews	no. theyll only fit a few specific rod ends and then id be left with tension rods with no spacers again.