Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post - S13 KA24DE Wiring Question (Coil and Resistor)

jumboflan · 08-29-2019, 10:16 PM

Im going to check fuel. I don't know if the ecu is sending injector pulses. Or not.but i plan to . I might just shoot starting fluid to intake and crank it. Just to verify if my piston froze I had a lot of moisture in my oil dipstick.i think my fuel tank had water in it. Because the trunk seal was old and rain dumped into the trunk and the o ring for the fuel pump was old. Too. So, in march 2018, i cleaned the gas tank up. I took my hand and wiped it down with paper towel. Alot of rust and sediment dirt was at the bottom. Half my fuel was water. Could i hydrolocked my engine in late 2017 when i was driving all the time while with water in my gas tank? unknowingly. thanks brndck @ Kennedy8383 How do i check resistance of the resistor if the casing its in is all melted.?

08-29-2019, 10:16 PM	#7
jumboflan Zilvia Junkie Join Date: Jun 2008 Location: San Francisco Age: 42 Posts: 327 Trader Rating: (2)	Im going to check fuel. I don't know if the ecu is sending injector pulses. Or not.but i plan to . I might just shoot starting fluid to intake and crank it. Just to verify if my piston froze I had a lot of moisture in my oil dipstick.i think my fuel tank had water in it. Because the trunk seal was old and rain dumped into the trunk and the o ring for the fuel pump was old. Too. So, in march 2018, i cleaned the gas tank up. I took my hand and wiped it down with paper towel. Alot of rust and sediment dirt was at the bottom. Half my fuel was water. Could i hydrolocked my engine in late 2017 when i was driving all the time while with water in my gas tank? unknowingly. thanks brndck @ Kennedy8383 How do i check resistance of the resistor if the casing its in is all melted.? __________________ Im immune to bullshit....so put your shovel away.