View Single Post
Old 02-16-2017, 09:36 AM   #9
240sxScores
Zilvia Junkie
 
240sxScores's Avatar
 
Join Date: May 2005
Location: Pocono's PA
Age: 37
Posts: 304
Trader Rating: (2)
240sxScores is making a name for him/her self240sxScores is making a name for him/her self
Send a message via AIM to 240sxScores
Quote:
Originally Posted by travon47 View Post
Z33 is not a r230, it is still a r200. The rear bushing did not fit on my 05 g35 auto trans. the knurl on the stud is too large for the bushing how it was machined and I had to modify it. Also like Jorgs said, they are a press fit and I have no idea how you can line these up properly while pressing them in, not to mention I hogged the shit out of my diff flanges on the front just to make it start to slip in for the first part( how these are machined).
Also I have a little bit of camber, but my axles are 100% compressed with the diff just sitting in the subframe without the mounts( hardly off from where it would sit) So it looks like extended rlca are a must, atleast for me.
My bad.

Could you measure the distance between the snout mounting holes then make a U shaped bracket with similar bolts. Slip bushings on bracket then hold up to differential and twist them until everything lines and press in

Sent from my XT1575 using Tapatalk
240sxScores is offline   Reply With Quote