I put some more hours into the car over the xmas period. We didnt get a chance to do much more welding at this point but I'd cleaned up the areas that were already done. Some in part and some ready to be primed. Also have removed 3 out of the 4 seat belt mounts with the linager in the rear. We tryed a spot weld drill bit and after drilling a hole straight through the floor decided to return the the linager. :P
The weekend following it would get another 10 hours plus from me alone to get it moving more.
Also needed to go and pickup the new S15 subframe I'd sourced and get moving on that.
Some pics!
Given some wirebrush to take off the (most) of the burnt paint and ****ness.
Same again
The towers after a grind and brush came up awesomely once these are sealed they're going to look exactly how I'd hoped! =D
Mount gone
The last remaining one with the spots dug out from sealant ready to be attacked.
Deleting these should allow my harness mounts to go in close to weight neutral.
Goooooone
Not sure how many of you have seen an S13 front end apart but these layers of metal were knowhere near each other to begin with! Beat them all together so they weld up nicely!
Back on the hoist
More soon! =)