Quote:
Originally Posted by NorcalAP2
Did you happen to try freezing them before trying to fit them in? Just curious to see if that would make enough of a difference.
Im not home to try and see how much shrinkage you would get from room temp vs freezing temp. I will do this when I get home and post results unless somebody beats me to it.
also - does the 240sx rear driveshaft flange mate up perfectly to the 350z one since they are R200's?
|
I tried but did not do anything, granted I did not heat up the diff. The driveshaft hub centric ring fits onto the diff but the holes on the diff are spread out farther resulting in needing to drill new holes in between the old ones. I had my bushings machined down .001, not quite sure if they fit yet since I have not got them back but will update once I do.