</span><table border="0" align="center" width="95%" cellpadding="3" cellspacing="1"><tr><td>
Quote (boosteds14 @ Aug. 30 2002,11:28)</td></tr><tr><td id="QUOTE"></span><table border="0" align="center" width="95%" cellpadding="3" cellspacing="1"><tr><td>
Quote </td></tr><tr><td id="QUOTE">I'm trying to figure out a way to put slots between each runner and increase the bolt hole sizes as they go from center to edges. This should allow room for thermal expansion and keep it from cracking.</td></tr></table><span id='postcolor'>
good idea <img src="http://www.zilvia.net/f/iB_html/non-cgi/emoticons/thumbs-up.gif" border="0" valign="absmiddle" alt=':thumbsup:'> <img src="http://www.zilvia.net/f/iB_html/non-cgi/emoticons/thumbs-up.gif" border="0" valign="absmiddle" alt=':thumbsup:'>
and another thing about the revhard is that it causes the bolts to unloose because the design. from what i hear</td></tr></table><span id='postcolor'>
I'm planning on checking all the bolts and stuff pretty frequently at first to make sure they're holding up. If worse, comes to worse, I could always safety wire 'em...or tack weld 'em <img src="http://www.zilvia.net/f/iB_html/non-cgi/emoticons/tounge.gif" border="0" valign="absmiddle" alt='
'> .