Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post

Eoken · 01-12-2017, 11:48 PM

Got some more welding done after much test fitting and measuring. I took the dash in and out about 5 times along with the seat a few times to make sure I was putting the master cylinder in just the right spot. Compared to where it was before it is more out of the way of my right leg because of the angle and should be slightly tighter fitting to the dash.

This was my first design, It seemed to be very stong but did not look how I wanted.

I made a plate for the front and used two diameter circle saws to make a 3D circular hole

Welded up and ground down.

Masked off the car lol.

filler primer to fill in those imperfections I could not get with the grinder.

The paint looks pretty good! Can't wait to see it with the carpet around it.

01-12-2017, 11:48 PM	#42
Eoken Zilvia Member Join Date: Feb 2015 Location: Austin, TX Posts: 188 Trader Rating: (1)	Got some more welding done after much test fitting and measuring. I took the dash in and out about 5 times along with the seat a few times to make sure I was putting the master cylinder in just the right spot. Compared to where it was before it is more out of the way of my right leg because of the angle and should be slightly tighter fitting to the dash. This was my first design, It seemed to be very stong but did not look how I wanted. I made a plate for the front and used two diameter circle saws to make a 3D circular hole Welded up and ground down. Masked off the car lol. filler primer to fill in those imperfections I could not get with the grinder. The paint looks pretty good! Can't wait to see it with the carpet around it.