Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post - s13 vert - 1jz vvti high idle and fuel cut issue

bdavis · 04-06-2016, 07:01 AM

BOV Issue - so my BOV doesn't work, I just have compressor surge. The BOV is hooked up as so from the factory with the electrical solenoid. I tried to by pass the solenoid and just run it off of vacuum the other day. Car started just fine, ran great but I found that it didn't have the normal boost and power it should. The BOV worked now, but when I was in low gears at high RPM, it would boost about 6 PSI, and then drop down to like 3. In high gears at low rpms, It would eventually build 10psi, but realllly slowly. So I hooked everything back up to factory and now I just have surge again. Sounds cool, but it would be nice to have this working properly. would this be an issue with the BOV or solenoid? or both?

04-06-2016, 07:01 AM	#11
bdavis Join Date: Feb 2009 Location: st peters mo Age: 37 Posts: 11 Trader Rating: (0)	BOV Issue - so my BOV doesn't work, I just have compressor surge. The BOV is hooked up as so from the factory with the electrical solenoid. I tried to by pass the solenoid and just run it off of vacuum the other day. Car started just fine, ran great but I found that it didn't have the normal boost and power it should. The BOV worked now, but when I was in low gears at high RPM, it would boost about 6 PSI, and then drop down to like 3. In high gears at low rpms, It would eventually build 10psi, but realllly slowly. So I hooked everything back up to factory and now I just have surge again. Sounds cool, but it would be nice to have this working properly. would this be an issue with the BOV or solenoid? or both?