Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post - MD FS: SR, Hood, OEM, Gaskets, 5spd Crossmember, emblems

BoostinIX · 06-13-2011, 09:09 AM

Stuff's taking up room, make offers.

All parts located at 20723. Will meet within reason. For paypal add 3%/Send as gift. As is/sales final. Feel free to PM questions, SR parts came off a Zerolift clean unmodified motorset, but have never personally used them.

-S14 SR20 Water Pump

20 P.U. / 25 Shipped

Bought a new water pump before disassembling the motor, and the old water pump looks brand-new inside. Might as well use the new one, so this one can go. Could essentially eat off it. Blades look great.

-Chaser CF Kouki Hood - Cheap!

Asking 200 (P.U. ONLY)

This HAS to go. Seriously. Make me an offer. Got 2 hoods too many in the garage. Needs to leave soon. Perfect chance for a cheap Kouki conversion.

The good:
Great at heat management. After carwash, can see it fog up the window with the raised rear section. Helped keep my engine nice and cool at the beginner's clinic. (factory cooling system, never went above 180)

Already drilled for AeroCatch latches. If you've had this done, you know this is a PITA/couple hours to get them perfect at a shop. Already drilled, ready to mount up new latches and go.

AeroCatch's not included.

The bad:
Has the standard clearcoat cracks from trying to use the stock hood latch, as well as more clear cracks on the drivers headlight area from a deer impact. Was low speed, deer more "bounced". Didn't hurt the hood, just the clearcoat.

-Stock SR manifold off my S14 SR.

50 P.U. / 60 Shipped

-OEM SR fly off my S14 SR

-50 P.U. / 65 Shipped (Heavy....)

Upgrading to lightweight, won't need.

-OEM S14 Metal turbo gasket

10 P.U. / 15 shipped

-10 OEM S14 SR20 Head Bolts (No washers)

-10 P.U. / 15 Shipped.

Yes, they're used. Yes, the FSM gives you the measurements for checking if you can reuse them, no I didn't measure them (don't have anything exact enough). I got a new set for cheap, so these can go.

-BNIB OEM S14 SR20 Head Gasket

25 P.U. / 35 shipped

Got this with my kit, but since gotten a MHG. Never installed.

-BNIB OEM S14 SR20 Exhaust Manifold Gasket

15 P.U. / 25 shipped

Came with kit, my Expreme manifold came with the 7 layer so no longer needed. Never installed

-OEM radiator cap

5 P.U. / 10 Shipped

Have Nismo and Mishimoto, don't need. Spares never hurt.

-5spd Crossmember

45 P.U. / 50 Shipped

Came off my S14 SR trans yesterday during prep, don't need as I'm already 5spd.

-Stock S14 "240SX" and "SE" Emblems

5 P.U. / 10 Shipped

Converted to different emblem setup, so these can go. No cracks I could see.

-New JDM S14 Silvia Hood Badge (Black w/ Silver "S")

15 P.U. / 20 Shipped

Was going to use this but decided not to put it on my Seibon. Still has original backing on the tape, unused

06-13-2011, 09:09 AM	#1
BoostinIX Zilvia Addict Join Date: Feb 2008 Location: Laurel, MD Age: 39 Posts: 815 Trader Rating: (29)	FS: SR, Hood, OEM, Gaskets, 5spd Crossmember, emblems Stuff's taking up room, make offers. All parts located at 20723. Will meet within reason. For paypal add 3%/Send as gift. As is/sales final. Feel free to PM questions, SR parts came off a Zerolift clean unmodified motorset, but have never personally used them. -S14 SR20 Water Pump 20 P.U. / 25 Shipped Bought a new water pump before disassembling the motor, and the old water pump looks brand-new inside. Might as well use the new one, so this one can go. Could essentially eat off it. Blades look great. -Chaser CF Kouki Hood - Cheap! Asking 200 (P.U. ONLY) This HAS to go. Seriously. Make me an offer. Got 2 hoods too many in the garage. Needs to leave soon. Perfect chance for a cheap Kouki conversion. The good: Great at heat management. After carwash, can see it fog up the window with the raised rear section. Helped keep my engine nice and cool at the beginner's clinic. (factory cooling system, never went above 180) Already drilled for AeroCatch latches. If you've had this done, you know this is a PITA/couple hours to get them perfect at a shop. Already drilled, ready to mount up new latches and go. AeroCatch's not included. The bad: Has the standard clearcoat cracks from trying to use the stock hood latch, as well as more clear cracks on the drivers headlight area from a deer impact. Was low speed, deer more "bounced". Didn't hurt the hood, just the clearcoat. -Stock SR manifold off my S14 SR. 50 P.U. / 60 Shipped -OEM SR fly off my S14 SR -50 P.U. / 65 Shipped (Heavy....) Upgrading to lightweight, won't need. -OEM S14 Metal turbo gasket 10 P.U. / 15 shipped -10 OEM S14 SR20 Head Bolts (No washers) -10 P.U. / 15 Shipped. Yes, they're used. Yes, the FSM gives you the measurements for checking if you can reuse them, no I didn't measure them (don't have anything exact enough). I got a new set for cheap, so these can go. -BNIB OEM S14 SR20 Head Gasket 25 P.U. / 35 shipped Got this with my kit, but since gotten a MHG. Never installed. -BNIB OEM S14 SR20 Exhaust Manifold Gasket 15 P.U. / 25 shipped Came with kit, my Expreme manifold came with the 7 layer so no longer needed. Never installed -OEM radiator cap 5 P.U. / 10 Shipped Have Nismo and Mishimoto, don't need. Spares never hurt. -5spd Crossmember 45 P.U. / 50 Shipped Came off my S14 SR trans yesterday during prep, don't need as I'm already 5spd. -Stock S14 "240SX" and "SE" Emblems 5 P.U. / 10 Shipped Converted to different emblem setup, so these can go. No cracks I could see. -New JDM S14 Silvia Hood Badge (Black w/ Silver "S") 15 P.U. / 20 Shipped Was going to use this but decided not to put it on my Seibon. Still has original backing on the tape, unused