Quote:
Originally Posted by racinjayson
This maybe a silly question, but do you think that there is a possibility of removing the bell housing to machine off the extra thickness and run an s14 flywheel? Or since that might misalign the starter, take the bell housing and section an inch out of it at the base which would pull the tranny closer without messing with the starter aliment. I think I'm going to try this and get back to this thread to report my findings because a 17lbs flywheel is just unacceptable when with the s14 setup you can have a 9.5lbs flywheel.
|
I would not recommend this. The transmission casing is made of cast aluminum, and you may weaken the integrity of the casting, which may lead to cracking.