Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post - Writeup: custom Koni and Ground Control coilover setup assembly

V1A · 08-03-2009, 07:02 PM

You're going to want to cut the flange off of the brass spacers you're using inside of the camber plates. That flange will eventually deform from the loads it will see when set up like that. I used a 4.5" cutoff wheel to hack it off, and a file to deburr it when I set mine up.

Also, it kind of sucks that you got the barrel shaped eibachs. With some dealers you have to specify that you want springs with a consistent OD. I'd try to send those back; otherwise you're going to lose more inside wheel/tire clearance than necessary.

08-03-2009, 07:02 PM	#3
V1A Join Date: Dec 2007 Location: PA Posts: 14 Trader Rating: (0)	You're going to want to cut the flange off of the brass spacers you're using inside of the camber plates. That flange will eventually deform from the loads it will see when set up like that. I used a 4.5" cutoff wheel to hack it off, and a file to deburr it when I set mine up. Also, it kind of sucks that you got the barrel shaped eibachs. With some dealers you have to specify that you want springs with a consistent OD. I'd try to send those back; otherwise you're going to lose more inside wheel/tire clearance than necessary.