Thread: Drilling wheel hub/rotor to change bolt pattern?
View Single Post
Old 03-03-2008, 02:10 AM   #3
DarkPhoenix
Zilvia Member
 
DarkPhoenix's Avatar
 
Join Date: Feb 2008
Location: South Huntington, NY
Age: 47
Posts: 247
Trader Rating: (0)
DarkPhoenix is a splendid one to beholdDarkPhoenix is a splendid one to beholdDarkPhoenix is a splendid one to beholdDarkPhoenix is a splendid one to beholdDarkPhoenix is a splendid one to beholdDarkPhoenix is a splendid one to beholdDarkPhoenix is a splendid one to beholdDarkPhoenix is a splendid one to beholdDarkPhoenix is a splendid one to beholdDarkPhoenix is a splendid one to beholdDarkPhoenix is a splendid one to behold
Send a message via ICQ to DarkPhoenix Send a message via AIM to DarkPhoenix
I think there is someone one who did a "ghetto 5 lug conversion" using the stock 4 lug hubs. It was either here or on s-chassis.com
__________________
1990 Nissan 240SX SE FB-KA24ET in progress!

Lotsa people with sandy holes on the interwebs!!
DarkPhoenix is offline   Reply With Quote