about the harness bar...
it looks you put some genuine thought into it, and it came out pretty well...i only have once concern.
granted you used the same mounting points as lets say a cusco cage...its not a cage..and will flex differently..especially when in an accident. from the looks of the photo's, it looks as if you took a hard enough front end hit, it would just move forward..using the bolt on the b pillar as a pivot point.
i know you realized this, and you put the mount on the bottom near the back seat..but that can still pivot...not much...but it can still move.
what would make it work a little better was if the lower piece of flat stock, was welded up near where it meets with the harness bar..this will prevent it from swinging in an accident.
__________________
|