Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post - This is the roll center, suspension pickup, and steering angle modification thread.

stuckonfresh · 10-28-2016, 07:16 AM

^wow, that. A lot of angle! And the rack is still able to go further if there were no obstructions?

..so just a hypothetical question for s chassis, or another chassis that would benefit from having an extra tooth or two cut into the rack, how would one go about doing this? Would it really need to be machined or could it be done by a skilled craftsman (or craftswoman) with an angle grinder/dremel and steady hand/jig setup?

10-28-2016, 07:16 AM	#7238
stuckonfresh Leaky Injector Join Date: Nov 2010 Location: in and out of areacodes Age: 38 Posts: 109 Trader Rating: (2)	^wow, that. A lot of angle! And the rack is still able to go further if there were no obstructions? ..so just a hypothetical question for s chassis, or another chassis that would benefit from having an extra tooth or two cut into the rack, how would one go about doing this? Would it really need to be machined or could it be done by a skilled craftsman (or craftswoman) with an angle grinder/dremel and steady hand/jig setup? __________________ Instagram: @cleantune