Quote:
Originally Posted by TheRealSy90
I see what you mean now. And then the heim joint offset spacers get installed after the heim length is set.
Sent from my iPhone using Tapatalk
|
Well yes and know. Ideally you want to remove them all, put just the bolt in, adjust it until you get it where you want it, and then put them in, however I found that even after doing that, I still found myself swapping spacers over for whatever reason. Once they’re installed though, you can still fine tune the tension rod length a bit. I don’t remember off hand but I want to say it was about 10mm or so either direction when spacers are in. Kinda cool. I love the setup overall, it’s pretty amazing on a few different levels. Highly recommended