Quote:
Originally Posted by mct3351
Well then that pulley wont work. If you were to compare the length of the moment arm of the s13 pulley on the s13 throttle body, with the length of the moment arm of an s14 pulley (installed backwards from the way its installed on an s14 throttle body) installed on an s13 throttle body, the way you have it, its about 4 times longer and the bending loads are 4 times more.
Since I'm blind and cant see that this is the only configurstion that will work the easiest thing to do, is make a pedal stop. This will limit the force pulling/bending on the end of the axle once its fully rotated and resting on its stop.
Or you can disregard my advise and do nothing and keep hoping for a different result.
|
You haven't looked at an S14 SR in a minute. It is installed just as I have it on my S13 SR throttle body. I don't think the moment arm is actually any different.
Quote:
Originally Posted by lok
"Insanity is doing the same thing over and over again but expecting different results." I am guessing you have already tried moving the mounting point for the throttle cable?
|
Obviously, and I don't plan to just re-install as without some alteration. I have not move the pull point yet. If you look at the first picture, its pretty nicely lined up. I really think I'm either over pulling the cable a few thousands or the S14 throttle body has some differences
Anybody have any pictures of an S14 SR throttle body?