Quote:
Originally Posted by w00tang
pack it with grease until it just comes out.
|
but you then must force the grease to force out the bushing. by filling up the inside of the PB with grease, and using a tool (i used a backwards socket with an extension in it so the end was flat) to pound the grease into the crank.....the grease forces the bushing out.
it's just relying on hydrostatic properties to pop out the old bushing
Quote:
Originally Posted by w00tang
pack it with grease until it just comes out.
i personally thing slidehammer is alot easier..
|
it's probably quicker and easier....but grease is a lot cheaper
