Quote:
Originally Posted by ZX88
odd question for those with blitz 03s? Was it difficult to reseat the faces into the lip/barrel. Mine are stock welded barrels and I want to refinish the faces. Do i need to hammer them in to get this to sit flush with the barrell/inner lip?
|
I had my 03 faces out for a repolish of the lips and I don't recall them being particularly difficult. I lightly tapped the faces with a rubber hammer because it is a tight fit but if you are wailing on it, something is wrong.
To avoid messing up a refinished surface, just get the face close enough for the nuts to thread on the bolts and tighten. That will pull them all the way through if they don't sit flat immediately. If you really don't what to hammer at all and the Blitz hardware is too short, you can grab some longer hardware from Lowes or whatever. Then tighten those and replace them with the Blitz stuff when the face is flush.