Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post

lumbo007 · 03-15-2010, 06:34 PM

So I have a '95 s14 se with s14 zenki sr swap in it. I think the car may have had a factory alarm (there is a hood sensor, and 4-wire power lock connector) but I accidentally threw away the stock alarm brain so I'm using the JDM one (which didn't have a hood sensor).

Here's my problem:
My drivers side power lock doesn't work but my passenger side works fine. I can use the switch or lock/unlock the drivers door and the passenger side will lock/unlock. I took out the actuator and plugged it into the passenger side and it works so it's not the actuator itself.

Anyone have any ideas what to check? I'm hoping it's just bad stock wiring and not the factory alarm. Any help would be appreciated.

03-15-2010, 06:34 PM	#1
lumbo007 Zilvia Member Join Date: May 2003 Location: Hawaii Posts: 160 Trader Rating: (0)	Power door lock help So I have a '95 s14 se with s14 zenki sr swap in it. I think the car may have had a factory alarm (there is a hood sensor, and 4-wire power lock connector) but I accidentally threw away the stock alarm brain so I'm using the JDM one (which didn't have a hood sensor). Here's my problem: My drivers side power lock doesn't work but my passenger side works fine. I can use the switch or lock/unlock the drivers door and the passenger side will lock/unlock. I took out the actuator and plugged it into the passenger side and it works so it's not the actuator itself. Anyone have any ideas what to check? I'm hoping it's just bad stock wiring and not the factory alarm. Any help would be appreciated. __________________ Even in darkness, a keen eye can detect light. Last edited by lumbo007; 03-15-2010 at 06:57 PM..