HOW TO REMOVE INJECTORS WITHOUT DAMAGING THEM
yes it can be a pain when they've been sitting in there for awhile.
The steps for removing one injector from the rail
•1 - break loose the two screws holding the injector cap on
•2- remove both screws
•3- remove cap
•4- put screws back down into the threaded holes, about halfway down
•5- with two small flat head screwdrivers, put them in the small slots on each side of the injector
•6- using the screws you put back in as leverage, push down on the screwdriver handles, this should force the injector up out of its place.
Be patient with it, if you're not getting enough leverage, bring the screws out a little more, giving you more leverage.
Hope this helps some of you guys out
__________________
__________________
Last edited by burnsauto; 05-09-2008 at 08:40 PM..
|