I FUDGED UP ?
I was repositioning my negative ground wires from the battery as they were installed pretty ''Janky'' from the previous owner. Where I messed up is I didn't disconnect the ground terminal 1st from the battery...
While I was moving the wire around it did arc a few times on the chassis. Now my car wont start. I did some initial troubleshooting but I'm no expert.
Things I've done so far;
1. Checked Fuses only found one burned- it was labeled 12V- I changed it.
2. Swapped some relays in & out that are labeled for ECM & Ignition.
3. Swapped out the ECU with a spare I had. Both the red led lights up.
4. Swapped out the Battery
5. Checked the big fuses in the engine bay. Swapped the 100amp & 75 amp.
That's as far as I've got so far. STILL NO LUCK. It just continues to turn over and crank but does not fire. All electronics light up, headlights, stereo, dash lights, etc. What else should I do or where to check next? Please Help Guys, Thank You!
Specs on car; 1995 zenki with a manual swap using a manual ecu. Ka24de engine with 136k.