Ka24de two dead cylinders SOS!!
Alright where to begin. lets just start from the beginning. One night I was going out to meet some friend and my engine seized out of nowhere. So I let out a sigh and went "240 life". I should note my current problem wasn't happening during this time. I figured I would rebuild the motor rebuilt it. It did not want to hold idle and when I tried to drive it was sluggish. pulled it and bought a brand new motor from a shop figuring I did something wrong. I installed it and i currently have a similar issue. The engine will start and hold idle at around 800 (while chugging like a v8 and shaking the piss out of the car) but when I give it gas it jerks furiously. I started pulling plug wire till I narrowed down my issue and it was cylinders 1 and 2. see if i could move around the issue by moving injectors and switching wires nothing. I bought some b12 chemical carb cleaner and it ran normally for maybe 1-2 minutes then back to shit. spraying it anywhere worked iacv and throttle body. Someone help i've been trying to get my car running for like 4 months now. I just wanna drive again.
New stuff:
Clutch
Pressure plate
flywheel
throw out bearing
Engine
recently cleaned iacv
distributor cap
tps sensor
plugs
injectors
fuel pump
fuel filter
distributor connector
battery
temp sensors x2
|