[derass]

Originally Posted by kashira kureijii

Circuit sports suspension arm package
Circuit sports inner and outer tie rods
FA 500 coils.

Can I align it myself? What would I need?

Here's my advice. After you have installed everything, first set the ride height. Setting the TC and Traction rod lengths is a bit tricky without the right equipment, TC especially. Just set TC length to stock, these cars have a ton of caster anyways.

Then set the traction rod length after reading this: http://www.nissanroadracing.com/showthread.php?t=1652

You can do most of the alignment yourself. I use this technique for toe and camber: http://www.negative-camber.org/jam14...alignment.html

Set the camber using the method in the first link. Anywhere between -0.5 and -3.0 is good. Just make sure it's even side-to-side and that there is more in the front than rear.

Finally set the toe. You want about 1/16" toe-in both front and rear.

Originally Posted by chaseaman

The belt broke when the provirus owner had it and he took the tensioner off along with the pulley the pump or lines never leaked to my knowledge

I find it very suspicious that instead of replacing a $10 dollar belt they chose to remove more parts. That's why I think it was leaking.