View Single Post
Old 07-06-2015, 06:24 PM   #7
dorkidori_s13
ITS LISA'S FAULT!!!
 
dorkidori_s13's Avatar
 
Join Date: Jun 2003
Location: Las Vegas
Age: 42
Posts: 7,492
Trader Rating: (41)
dorkidori_s13 is close to perfectiondorkidori_s13 is close to perfectiondorkidori_s13 is close to perfectiondorkidori_s13 is close to perfectiondorkidori_s13 is close to perfectiondorkidori_s13 is close to perfectiondorkidori_s13 is close to perfectiondorkidori_s13 is close to perfectiondorkidori_s13 is close to perfectiondorkidori_s13 is close to perfectiondorkidori_s13 is close to perfection
Quote:
Originally Posted by S-Nation S13 View Post
and picked up an O'Reilly set of axles...
thats your problem right there.

unfortunately, brand new OE axles are no longer in existence and 9 out of 10 aftermarket axles you purchase are remans.

i would highly suggest purchasing a set of Driveshaft Shop axles if you want brand new (which is going to run $400-$500, but will support up to 500whp)... outside of that youre going to keep running into the same problem. i went thru 3 drivers side aftermarket OE replacements and 2 passengers from RockAuto before i said screw it and had my OE axles rebooted and regreased. all of the Rock Auto axles clicked and clunked during acceleration and turning (they didnt even fit snug into the hub compared to the OEs). my OEs were just fine, they needed new boots was all so i had a friends shop take care of it (theres a specific tool needed to reboot axles, it stretches the rubber boot over the axle properly).
__________________


Check out my IG for what I'm up to! DORKIDORI INSTAGRAM!!!
dorkidori_s13 is offline   Reply With Quote