Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post

iDowny · 02-07-2015, 09:51 PM

It's sounding like you cannot exchange flanges due to some c rings not lining up. Is there another axle shaft that would work for this setup? I'm almost certain it's a 93 vlsd out of a j30 now. Searched and called everywhere around town to get the same answer " o boy you won't like this. We don't have them and cannot order them" help pls xD

*EDIT*
Would these work?

I was reading and people said that the drivers side fits nicely but the passenger side is about an inch too short, and that they use j30 passenger side. Also some saying they both fit.

http://www.ebay.com/itm/jdm-Nissan-S...-/400755793862

i am needing to replace rear passenger side only and am needing to know if this would bolt up, been searching and everyone seems to contradict each other. I cant just buy one and hope that it works. money money.

02-07-2015, 09:51 PM	#2
iDowny Join Date: Feb 2015 Location: Washington Age: 31 Posts: 4 Trader Rating: (0)	It's sounding like you cannot exchange flanges due to some c rings not lining up. Is there another axle shaft that would work for this setup? I'm almost certain it's a 93 vlsd out of a j30 now. Searched and called everywhere around town to get the same answer " o boy you won't like this. We don't have them and cannot order them" help pls xD EDIT Would these work? I was reading and people said that the drivers side fits nicely but the passenger side is about an inch too short, and that they use j30 passenger side. Also some saying they both fit. http://www.ebay.com/itm/jdm-Nissan-S...-/400755793862 i am needing to replace rear passenger side only and am needing to know if this would bolt up, been searching and everyone seems to contradict each other. I cant just buy one and hope that it works. money money. Last edited by iDowny; 02-08-2015 at 04:19 AM..