|
Also had another question. Before I pulled the 1jz out of my other car, the car would not start. I had signal to both spark plugs and fuel injectors, if I sprayed some brake clean into the manifold the car would start so i'm obviously not getting fuel... I tested the fuel pressure on my AEM fuel pump and i was reading 52psi. Then I went on to check the pressure on the stock FPR and it read's 0.. My questions are, is 52psi to much pressure for a stock FPR? or is it just that my FPR just crapped out... The car did start before untill we had an issue with an O-Ring for the gas tank went bad but the pump was only flowing at 43psi before we changed the O-Ring. Also I have a 40amp relay on the pump could that also be an issue? I dont see why but then again im not to good with anything electrical...
|