Problem solved see below!
just recently installed my PBM subframe risers, read up on the thread they provided..
http://www.gtfactory.jp/cms/e107_fil...9_p1040244.jpg
In the thread it was recommended to hammer/cut the uni body where the camber arms are located, but i noticed my arms are closer than the car pictured, so i have an even shorter travel. Also if i were to hammer both sides of my uni body I'd have problems in pic2 because i have EGR lines right there
.
I have bombarded Dan and Martin with questions and they've gladly answered them all
And they will be getting a call tomorrow lol but im just trying to gather input on this situation. If the pictures suck ill try and snap some better pics soon.
pic1
pic2(pass side) EGR lines
pic3(driver) uni body non cut/hammered
note: pictures taken with the car on the ground, car is s14